Amontec JTAGKey config

[proxmark3-svn] / common / ldscript.common

/* AT91SAM7S256 has 256k Flash and 64k RAM */
MEMORY 
{
	/* Important note: this memory map has the correct origins for all the flash sections.
	   However, this will confuse the currently deployed flash code which expects logical and and not
	   physical addresses and performs no sanity checks at all. If confronted with physical addresses, 
	   it will happily erase everything and brick the device. So for the time being translate these addresses
	   down in the objcopy call while updating all the flash code with proper sanity checks, then come
	   back later and fix the addresses. -- Henryk Plötz <henryk@ploetzli.ch> 2009-08-27 */
        bootphase1 : ORIGIN = 0x00100000, LENGTH = 0x200 /* Phase 1 bootloader: Copies real bootloader to RAM */
        bootphase2 : ORIGIN = 0x00100200, LENGTH = 0x2000 - 0x200 /* Main bootloader code, stored in Flash, executed from RAM */
        fpgaimage  : ORIGIN = 0x00102000, LENGTH = 64k - 0x2000 /* Place where the FPGA image will end up */
        osimage    : ORIGIN = 0x00110000, LENGTH = 256K - 64k /* Place where the main OS will end up */
        ram        : ORIGIN = 0x00200000, LENGTH = 64K - 0x20 /* RAM, minus small common area */
        commonarea : ORIGIN = 0x00200000 + 64K - 0x20, LENGTH = 0x20 /* Communication between bootloader and main OS */
}

/* Export some information that can be used from within the firmware */
_bootphase1_version_pointer = ORIGIN(bootphase1) + LENGTH(bootphase1) - 0x4;
_osimage_entry = ORIGIN(osimage);
_bootrom_start = ORIGIN(bootphase1);
_bootrom_end = ORIGIN(bootphase2) + LENGTH(bootphase2);
_flash_start = ORIGIN(bootphase1);
_flash_end = ORIGIN(osimage) + LENGTH(osimage);
_stack_end = ORIGIN(ram) + LENGTH(ram) - 8;