make grid function linux friendly

[proxmark3-svn] / armsrc / fpga.c

diff --git a/armsrc/fpga.c b/armsrc/fpga.c
index 2bcade280bd139993919196a82f359e5ddc3aa99..059fc82a65e62a4619ed9c19a633e9299ad2707e 100644 (file)
--- a/armsrc/fpga.c
+++ b/armsrc/fpga.c
@@ -53,7 +53,7 @@ void SetupSpi(int mode)
                                ( 1 << 24)      |       // Delay between Consecutive Transfers (32 MCK periods)\r
                                ( 1 << 16)      |       // Delay Before SPCK (1 MCK period)\r
                                ( 6 << 8)       |       // Serial Clock Baud Rate (baudrate = MCK/6 = 24Mhz/6 = 4M baud\r
-                               ( 0 << 4)       |       // Bits per Transfer (8 bits)\r
+                               ( 8 << 4)       |       // Bits per Transfer (16 bits)\r
                                ( 0 << 3)       |       // Chip Select inactive after transfer\r
                                ( 1 << 1)       |       // Clock Phase data captured on leading edge, changes on following edge\r
                                ( 0 << 0);              // Clock Polarity inactive state is logic 0\r
@@ -185,15 +185,25 @@ void FpgaDownloadAndGo(void)
        LED_D_OFF();\r
 }\r
 \r
+//-----------------------------------------------------------------------------\r
+// Send a 16 bit command/data pair to the FPGA.\r
+// The bit format is:  C3 C2 C1 C0 D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0\r
+// where C is the 4 bit command and D is the 12 bit data\r
+//-----------------------------------------------------------------------------\r
+void FpgaSendCommand(WORD cmd, WORD v)\r
+{\r
+       SetupSpi(SPI_FPGA_MODE);\r
+       while ((SPI_STATUS & SPI_STATUS_TX_EMPTY) == 0);                // wait for the transfer to complete\r
+       SPI_TX_DATA = SPI_CONTROL_LAST_TRANSFER | cmd | v;              // send the data\r
+}\r
 //-----------------------------------------------------------------------------\r
 // Write the FPGA setup word (that determines what mode the logic is in, read\r
-// vs. clone vs. etc.).\r
+// vs. clone vs. etc.). This is now a special case of FpgaSendCommand() to\r
+// avoid changing this function's occurence everywhere in the source code.\r
 //-----------------------------------------------------------------------------\r
 void FpgaWriteConfWord(BYTE v)\r
 {\r
-       SetupSpi(SPI_FPGA_MODE);\r
-       while ((SPI_STATUS & SPI_STATUS_TX_EMPTY) == 0);        // wait for the transfer to complete\r
-       SPI_TX_DATA = SPI_CONTROL_LAST_TRANSFER | v;            // send the data\r
+       FpgaSendCommand(FPGA_CMD_SET_CONFREG, v);\r
 }\r
 \r
 //-----------------------------------------------------------------------------\r