#define CMD_FINISH_WRITE 0x0003\r
#define CMD_HARDWARE_RESET 0x0004\r
#define CMD_START_FLASH 0x0005\r
+#define CMD_NACK 0x00fe\r
#define CMD_ACK 0x00ff\r
\r
// For general mucking around\r
#define CMD_LCD 0x0104\r
#define CMD_BUFF_CLEAR 0x0105\r
#define CMD_READ_MEM 0x0106\r
+#define CMD_VERSION 0x0107\r
\r
// For low-frequency tags\r
#define CMD_READ_TI_TYPE 0x0202\r
#define CMD_HID_DEMOD_FSK 0x020B\r
#define CMD_HID_SIM_TAG 0x020C\r
#define CMD_SET_LF_DIVISOR 0x020D\r
+#define CMD_LF_SIMULATE_BIDIR 0x020E\r
+#define CMD_SET_ADC_MUX 0x020F\r
+/* CMD_SET_ADC_MUX: ext1 is 0 for lopkd, 1 for loraw, 2 for hipkd, 3 for hiraw */\r
\r
// For the 13.56 MHz tags\r
#define CMD_ACQUIRE_RAW_ADC_SAMPLES_ISO_15693 0x0300\r
#define CMD_SIMULATE_TAG_ISO_14443a 0x0384\r
#define CMD_READER_ISO_14443a 0x0385\r
#define CMD_SIMULATE_MIFARE_CARD 0x0386\r
+#define CMD_SIMULATE_TAG_LEGIC_RF 0x387\r
\r
// For measurements of the antenna tuning\r
#define CMD_MEASURE_ANTENNA_TUNING 0x0400\r
// For direct FPGA control\r
#define CMD_FPGA_MAJOR_MODE_OFF 0x0500\r
\r
+// CMD_DEVICE_INFO response packet has flags in ext1, flag definitions:\r
+#define DEVICE_INFO_FLAG_BOOTROM_PRESENT (1<<0) /* Whether a bootloader that understands the common_area is present */ \r
+#define DEVICE_INFO_FLAG_OSIMAGE_PRESENT (1<<1) /* Whether a osimage that understands the common_area is present */\r
+#define DEVICE_INFO_FLAG_CURRENT_MODE_BOOTROM (1<<2) /* Set if the bootloader is currently executing */\r
+#define DEVICE_INFO_FLAG_CURRENT_MODE_OS (1<<3) /* Set if the OS is currently executing */\r
+#define DEVICE_INFO_FLAG_UNDERSTANDS_START_FLASH (1<<4) /* Set if this device understands the extend start flash command */\r
+\r
+// CMD_START_FLASH may have three arguments: start of area to flash, end of area to flash, optional magic defined below\r
+#define START_FLASH_MAGIC 0x54494f44 /* The bootrom will not allow to overwrite itself unless this magic is given as third parameter */\r
+\r
#endif\r