wire adc_clk;
assign adc_clk = ck_1356meg;
-reg after_hysteresis, after_hysteresis_prev1, after_hysteresis_prev2, after_hysteresis_prev3, after_hysteresis_prev4;
+reg after_hysteresis, pre_after_hysteresis, after_hysteresis_prev1, after_hysteresis_prev2, after_hysteresis_prev3, after_hysteresis_prev4;
reg [11:0] has_been_low_for;
reg [8:0] saw_deep_modulation;
reg [2:0] deep_counter;
begin
if(& adc_d[7:6]) after_hysteresis <= 1'b1; // adc_d >= 196 (U >= 3,28V) -> after_hysteris = 1
else if(~(| adc_d[7:4])) after_hysteresis <= 1'b0; // if adc_d <= 15 (U <= 1,13V) -> after_hysteresis = 0
+
+ pre_after_hysteresis <= after_hysteresis;
if(~(| adc_d[7:0])) // if adc_d == 0 (U <= 0,94V)
begin
reg temp_buffer_reset;
reg sendbit;
reg [3:0] sub_carrier_cnt;
+reg[3:0] reader_falling_edge_time;
// ADC data appears on the rising edge, so sample it on the falling edge
always @(negedge adc_clk)
sendbit = 1'b0;
end
+
+
+ // check timing of a falling edge in reader signal
+ if (pre_after_hysteresis && ~after_hysteresis)
+ reader_falling_edge_time[3:0] <= negedge_cnt[3:0];
+ else
+ reader_falling_edge_time[3:0] <= 4'd8;
+
+
+
+ // sync clock to external reader's clock:
+ if (negedge_cnt[3:0] == 4'd13 && (mod_type == `SNIFFER || mod_type == `TAGSIM_MOD || mod_type == `TAGSIM_LISTEN))
+ begin
+ // adjust clock if necessary:
+ if (reader_falling_edge_time < 4'd8 && reader_falling_edge_time > 4'd1)
+ begin
+ negedge_cnt <= negedge_cnt; // freeze time
+ end
+ else if (reader_falling_edge_time == 4'd8)
+ begin
+ negedge_cnt <= negedge_cnt + 1; // the desired state. Advance as usual;
+ end
+ else
+ begin
+ negedge_cnt[3:0] <= 4'd15; // time warp
+ end
+ reader_falling_edge_time <= 4'd8; // only once per detected rising edge
+ end
+
+
+
//------------------------------------------------------------------------------------------------------------------------------------------
// Prepare 8 Bits to communicate to ARM
-
- // in SNIFFER mode: 4 Bits data sniffed as Tag, 4 Bits data sniffed as Reader
- if(mod_type == `SNIFFER)
+ if (negedge_cnt == 7'd63)
begin
- if (negedge_cnt == 7'd63)
+ if (mod_type == `SNIFFER)
begin
if(deep_modulation) // a reader is sending (or there's no field at all)
begin
else
begin
to_arm <= {after_hysteresis_prev1,after_hysteresis_prev2,after_hysteresis_prev3,after_hysteresis_prev4,bit1,bit2,bit3,bit4};
- end
+ end
negedge_cnt <= 0;
end
else
begin
negedge_cnt <= negedge_cnt + 1;
end
- end
- else
- // other modes: 8 Bits info on queue delay
+ end
+ else if(negedge_cnt == 7'd127)
begin
- if(negedge_cnt == 7'd127)
+ if (mod_type == `TAGSIM_MOD)
begin
- if (mod_type == `TAGSIM_MOD)
- begin
- to_arm[7:0] <= {mod_sig_ptr[4:0], mod_sig_flip[3:1]};
- end
- else
- begin
- to_arm[7:0] <= 8'd0;
- end
+ to_arm[7:0] <= {mod_sig_ptr[4:0], mod_sig_flip[3:1]};
negedge_cnt <= 0;
end
else
begin
- negedge_cnt <= negedge_cnt + 1;
+ to_arm[7:0] <= 8'd0;
+ negedge_cnt <= negedge_cnt + 1;
end
end
+ else
+ begin
+ negedge_cnt <= negedge_cnt + 1;
+ end
+
if(negedge_cnt == 7'd1)
begin