X-Git-Url: http://cvs.zerfleddert.de/cgi-bin/gitweb.cgi/proxmark3-svn/blobdiff_plain/467340996e7af6563070df2c96c374e6a97b1456..e57c8b2e5601aacd3655a7c1a5c47a7cab66d914:/fpga/hi_read_rx_xcorr.v

diff --git a/fpga/hi_read_rx_xcorr.v b/fpga/hi_read_rx_xcorr.v
index f816199e..80e36327 100644
--- a/fpga/hi_read_rx_xcorr.v
+++ b/fpga/hi_read_rx_xcorr.v
@@ -28,11 +28,18 @@ assign pwr_oe1 = 1'b0;
 assign pwr_oe3 = 1'b0;
 assign pwr_oe4 = 1'b0;
 
-wire adc_clk = ck_1356megb;
-
-reg fc_div_2;
+// Clock divider
+reg [0:0] fc_divider;
 always @(negedge ck_1356megb)
-    fc_div_2 <= fc_div_2 + 1;
+    fc_divider <= fc_divider + 1;
+wire fc_div2 = fc_divider[0];
+
+reg adc_clk;
+always @(ck_1356megb)
+	if (xcorr_is_848)
+		adc_clk <= ck_1356megb;
+	else
+		adc_clk <= fc_div2;
 
 // When we're a reader, we just need to do the BPSK demod; but when we're an
 // eavesdropper, we also need to pick out the commands sent by the reader,
@@ -77,7 +84,6 @@ reg ssp_frame;
 
 always @(negedge adc_clk)
 begin
-	if (xcorr_is_848 | fc_div_2)
 		corr_i_cnt <= corr_i_cnt + 1;
 end		
 		
@@ -88,7 +94,7 @@ begin
     // These are the correlators: we correlate against in-phase and quadrature
     // versions of our reference signal, and keep the (signed) result to
     // send out later over the SSP.
-    if(corr_i_cnt == 7'd0)
+    if(corr_i_cnt == 6'd0)
     begin
         if(snoop)
         begin
@@ -123,7 +129,7 @@ begin
 
     // The logic in hi_simulate.v reports 4 samples per bit. We report two
     // (I, Q) pairs per bit, so we should do 2 samples per pair.
-    if(corr_i_cnt == 6'd31)
+    if(corr_i_cnt == 6'd32)
         after_hysteresis_prev <= after_hysteresis;
 
     // Then the result from last time is serialized and send out to the ARM.
@@ -137,7 +143,7 @@ begin
     begin
         ssp_clk <= 1'b1;
         // Don't shift if we just loaded new data, obviously.
-        if(corr_i_cnt != 7'd0)
+        if(corr_i_cnt != 6'd0)
         begin
             corr_i_out[7:0] <= {corr_i_out[6:0], corr_q_out[7]};
             corr_q_out[7:1] <= corr_q_out[6:0];