News (2008-03-26): Xilinx has released their own drivers based on libusb with ISE Design Suite 10.1.
+ To use them, you need to set the environment-variable XIL_IMPACT_USE_LIBUSB to 1
+ before running the tools. The driver on this page no longer needs to be preloaded if you only used
+ it to access USB cables. Parallel port support still seems to rely on windrvr, which can be
+ emulated by libusb-driver.
+ Using 32-bit ISE 10.1 on a 64-bit platform: When using the 32-bit JTAG tools from ISE Design
+ Suite 10.1 on a 64-bit machine, the tools will not connect to the cable but output the following
+ error: Cable operation is not supported when running the 32-bit version of the application on a
+ 64-bit platform.
+ To fix this, run the tools with linux32 or preload the newest 32-bit version of
+ libusb-driver. This will lead the tools to believe that they are running on a 32-bit
+ platform and allows them to connect to the cables.
+
When using XILINX JTAG software like Impact, Chipscope and XMD - on Linux, the proprietary kernel windrvr module from Jungo + on Linux, the proprietary kernel module windrvr from Jungo is needed to access the parallel- or usb-cable. As this module does not work with current linux kernel versions (> 2.6.18) a library was developed, which emulates the module in userspace and allows the tools to access the JTAG cable without the need @@ -16,55 +29,79 @@
The library uses libusb to access USB devices and the - ppdev interface to communicate + ppdev interface to communicate with parallel cables. The parallel part currently only supports Parallel Cable III mode (and PCIV in PCIII compatibility mode) as the faster PCIV modes use another kernel module which is not emulated by this library. So you are limited to a 200kHz JTAG clock when using Parallel Cable IV with this software. The USB cable is supported at full speed.
+ Experimental support for FTDI 2232 based devices has been added. They are seen by Impact as a Parallel + Cable III. These devices are currently significantly slower than every other supported cable. +
+The library is called libusb-driver as it was developed to support the USB cable, but later extended to also support parallel cables.