2 These are command definitions. This file should correspond exactly to usb_cmd.h.
4 --// For the bootloader
6 CMD_DEVICE_INFO = 0x0000,
7 CMD_SETUP_WRITE = 0x0001,
8 CMD_FINISH_WRITE = 0x0003,
9 CMD_HARDWARE_RESET = 0x0004,
10 CMD_START_FLASH = 0x0005,
14 --// For general mucking around
15 CMD_DEBUG_PRINT_STRING = 0x0100,
16 CMD_DEBUG_PRINT_INTEGERS = 0x0101,
17 CMD_DEBUG_PRINT_BYTES = 0x0102,
18 CMD_LCD_RESET = 0x0103,
20 CMD_BUFF_CLEAR = 0x0105,
21 CMD_READ_MEM = 0x0106,
25 CMD_DOWNLOAD_EML_BIGBUF = 0x0110,
26 CMD_DOWNLOADED_EML_BIGBUF = 0x0111,
28 --// For low-frequency tags
29 CMD_READ_TI_TYPE = 0x0202,
30 CMD_WRITE_TI_TYPE = 0x0203,
31 CMD_DOWNLOADED_RAW_BITS_TI_TYPE = 0x0204,
32 CMD_ACQUIRE_RAW_ADC_SAMPLES_125K = 0x0205,
33 CMD_MOD_THEN_ACQUIRE_RAW_ADC_SAMPLES_125K = 0x0206,
34 CMD_DOWNLOAD_RAW_ADC_SAMPLES_125K = 0x0207,
35 CMD_DOWNLOADED_RAW_ADC_SAMPLES_125K = 0x0208,
36 CMD_DOWNLOADED_SIM_SAMPLES_125K = 0x0209,
37 CMD_SIMULATE_TAG_125K = 0x020A,
38 CMD_HID_DEMOD_FSK = 0x020B,
39 CMD_HID_SIM_TAG = 0x020C,
40 CMD_SET_LF_DIVISOR = 0x020D,
41 CMD_LF_SIMULATE_BIDIR = 0x020E,
42 CMD_SET_ADC_MUX = 0x020F,
43 CMD_HID_CLONE_TAG = 0x0210,
44 CMD_EM410X_WRITE_TAG = 0x0211,
45 CMD_INDALA_CLONE_TAG = 0x0212,
47 CMD_INDALA_CLONE_TAG_L = 0x0213,
48 CMD_T55XX_READ_BLOCK = 0x0214,
49 CMD_T55XX_WRITE_BLOCK = 0x0215,
50 CMD_T55XX_RESET_READ = 0x0216,
51 CMD_PCF7931_READ = 0x0217,
52 CMD_PCF7931_WRITE = 0x0223,
53 CMD_EM4X_READ_WORD = 0x0218,
54 CMD_EM4X_WRITE_WORD = 0x0219,
55 CMD_IO_DEMOD_FSK = 0x021A,
56 CMD_IO_CLONE_TAG = 0x021B,
57 CMD_EM410X_DEMOD = 0x021c,
58 CMD_SET_LF_SAMPLING_CONFIG = 0x021d,
59 CMD_FSK_SIM_TAG = 0x021E,
60 CMD_ASK_SIM_TAG = 0x021F,
61 CMD_PSK_SIM_TAG = 0x0220,
62 CMD_AWID_DEMOD_FSK = 0x0221,
63 CMD_VIKING_CLONE_TAG = 0x0222,
64 CMD_T55XX_WAKEUP = 0x0224,
66 --/* CMD_SET_ADC_MUX: ext1 is 0 for lopkd, 1 for loraw, 2 for hipkd, 3 for hiraw */
68 --// For the 13.56 MHz tags
69 CMD_ACQUIRE_RAW_ADC_SAMPLES_ISO_15693 = 0x0300,
70 CMD_READ_SRI512_TAG = 0x0303,
71 CMD_READ_SRIX4K_TAG = 0x0304,
72 CMD_ISO_14443B_COMMAND = 0x0305,
73 CMD_READER_ISO_15693 = 0x0310,
74 CMD_SIMTAG_ISO_15693 = 0x0311,
75 CMD_RECORD_RAW_ADC_SAMPLES_ISO_15693 = 0x0312,
76 CMD_ISO_15693_COMMAND = 0x0313,
77 CMD_ISO_15693_COMMAND_DONE = 0x0314,
78 CMD_ISO_15693_FIND_AFI = 0x0315,
79 CMD_ISO_15693_DEBUG = 0x0316,
80 CMD_LF_SNOOP_RAW_ADC_SAMPLES = 0x0317,
82 --// For Hitag2 transponders
83 CMD_SNOOP_HITAG = 0x0370,
84 CMD_SIMULATE_HITAG = 0x0371,
85 CMD_READER_HITAG = 0x0372,
88 CMD_TEST_HITAGS_TRACES = 0x0367,
89 CMD_SIMULATE_HITAG_S = 0x0368,
90 CMD_READ_HITAG_S = 0x0373,
91 CMD_WR_HITAG_S = 0x0375,
92 CMD_EMU_HITAG_S = 0x0376,
94 CMD_SIMULATE_TAG_ISO_14443B = 0x0381,
95 CMD_SNOOP_ISO_14443B = 0x0382,
96 CMD_SNOOP_ISO_14443a = 0x0383,
97 CMD_SIMULATE_TAG_ISO_14443a = 0x0384,
98 CMD_READER_ISO_14443a = 0x0385,
99 CMD_SIMULATE_TAG_LEGIC_RF = 0x0387,
100 CMD_READER_LEGIC_RF = 0x0388,
101 CMD_WRITER_LEGIC_RF = 0x0389,
102 CMD_EPA_PACE_COLLECT_NONCE = 0x038A,
103 CMD_EPA_PACE_REPLAY = 0x038B,
105 CMD_ICLASS_READCHECK = 0x038F,
106 CMD_ICLASS_CLONE = 0x0390,
107 CMD_ICLASS_DUMP = 0x0391,
108 CMD_SNOOP_ICLASS = 0x0392,
109 CMD_SIMULATE_TAG_ICLASS = 0x0393,
110 CMD_READER_ICLASS = 0x0394,
111 CMD_READER_ICLASS_REPLAY = 0x0395,
112 CMD_ICLASS_READBLOCK = 0x0396,
113 CMD_ICLASS_WRITEBLOCK = 0x0397,
114 CMD_ICLASS_EML_MEMSET = 0x0398,
115 CMD_ICLASS_AUTHENTICATION = 0x0399,
117 --// For measurements of the antenna tuning
118 CMD_MEASURE_ANTENNA_TUNING = 0x0400,
119 CMD_MEASURE_ANTENNA_TUNING_HF = 0x0401,
120 CMD_MEASURED_ANTENNA_TUNING = 0x0410,
121 CMD_LISTEN_READER_FIELD = 0x0420,
123 --// For direct FPGA control
124 CMD_FPGA_MAJOR_MODE_OFF = 0x0500,
126 --// For mifare commands
127 CMD_MIFARE_SET_DBGMODE = 0x0600,
128 CMD_MIFARE_EML_MEMCLR = 0x0601,
129 CMD_MIFARE_EML_MEMSET = 0x0602,
130 CMD_MIFARE_EML_MEMGET = 0x0603,
131 CMD_MIFARE_EML_CARDLOAD = 0x0604,
133 --// magic chinese card commands
134 CMD_MIFARE_CSETBLOCK = 0x0605,
135 CMD_MIFARE_CGETBLOCK = 0x0606,
136 CMD_MIFARE_CIDENT = 0x0607,
138 CMD_SIMULATE_MIFARE_CARD = 0x0610,
140 CMD_READER_MIFARE = 0x0611,
141 CMD_MIFARE_NESTED = 0x0612,
142 CMD_MIFARE_ACQUIRE_ENCRYPTED_NONCES = 0x0613,
144 CMD_MIFARE_READBL = 0x0620,
145 CMD_MIFAREU_READBL = 0x0720,
147 CMD_MIFARE_READSC = 0x0621,
148 CMD_MIFAREU_READCARD = 0x0721,
150 CMD_MIFARE_WRITEBL = 0x0622,
151 CMD_MIFAREU_WRITEBL = 0x0722,
152 CMD_MIFAREU_WRITEBL_COMPAT = 0x0723,
154 CMD_MIFARE_CHKKEYS = 0x0623,
156 CMD_MIFARE_SNIFFER = 0x0630,
159 CMD_MIFAREUC_AUTH = 0x0724,
160 CMD_MIFAREUC_SETPWD = 0x0727,
161 CMD_MIFAREU_SETUID = 0x0728,
164 CMD_MIFARE_DESFIRE_READBL = 0x0728,
165 CMD_MIFARE_DESFIRE_WRITEBL = 0x0729,
166 CMD_MIFARE_DESFIRE_AUTH1 = 0x072a,
167 CMD_MIFARE_DESFIRE_AUTH2 = 0x072b,
168 CMD_MIFARE_DES_READER = 0x072c,
169 CMD_MIFARE_DESFIRE_INFO = 0x072d,
170 CMD_MIFARE_DESFIRE = 0x072e,
171 CMD_HF_SNIFFER = 0x0800,
173 CMD_UNKNOWN = 0xFFFF,
177 local _reverse_lookup,k,v = {}
178 for k, v in pairs(_commands) do
179 _reverse_lookup[v] = k
181 _commands.tostring = function(command)
182 if(type(command) == 'number') then
183 return ("%s (%d)"):format(_reverse_lookup[command]or "ERROR UNDEFINED!", command)
185 return ("Error, numeric argument expected, got : %s"):format(tostring(command))
190 new = function(self, o)
192 local o = o or {} -- create object if user does not provide one
193 setmetatable(o, self) -- DIY inheritance a'la javascript
196 o.cmd = o.cmd or _commands.CMD_UNKNOWN
200 local data = o.data or "0"
202 if(type(data) == 'string') then
203 -- We need to check if it is correct length, otherwise pad it
204 local len = string.len(data)
206 --Should be 1024 hex characters to represent 512 bytes of data
207 data = data .. string.rep("0",1024 - len )
210 -- OOps, a bit too much data here
211 print( ( "WARNING: data size too large, was %s chars, will be truncated "):format(len) )
213 data = data:sub(1,1024)
216 print(("WARNING; data was NOT a (hex-) string, but was %s"):format(type(data)))
221 parse = function(packet)
222 local count, cmd, arg1, arg2, arg3, data = bin.unpack('LLLLH511', packet)
223 return Command:new{cmd = cmd, arg1 = arg1, arg2 = arg2, arg3 = arg3, data = data}
227 function Command:__tostring()
228 local output = ("%s\r\nargs : (%s, %s, %s)\r\ndata:\r\n%s\r\n"):format(
229 _commands.tostring(self.cmd),
236 function Command:getBytes()
237 --If a hex-string has been used
238 local data = self.data
240 local arg1, arg2, arg3 = self.arg1, self.arg2, self.arg3
241 return bin.pack("LLLLH",cmd, arg1, arg2, arg3, data);